FixTech

A SIMPLE RANGE WITH GREAT RESULTS

Multipurpose products mean less items needed to provide a comprehensive solution and with modern technology this results in a simple application process making your job easier and faster. 

THE IDEAL SOLUTION WITH EASY MULTIPURPOSE ADHESIVES & SEALANTS

Fixtech offers the best quality range of products that reduces stock requirements and risk for fabricators.  Not only for health and safety reasons but are also setting new standards for UV resistance and colour stability, chalking resistance, product user friendliness, strength, paintability and logevity.

Fixtech adhesive/sealants can be applied to a wide variety of surfaces and rarely requires a primer making it extremely easy and safe for fabricators and their employees.  The range does not require you to become experts in adhesive technology.

WHY MS ADHESIVES & SEALANTS

Benefits

• Non Yellowing Whites and UV stabilized colours
• Non-Hazardous MS Polmer marine, transport and construction products that do not contain acids, VOC's, solvents, silicone or toxic materials such as Isocyanate that are found in polurethanes
• High UV, temperature and environmental resistance
• Paintable and resistant to mould and mildew.  Fix8 & Fix1DC not paintable
• Excellent tooling properties
• Continues to stay flexible over long periods of UV and heat exposure
• Suitable for all uses above and below the waterline, excellent UV weather exposure
• Does not stain Granite, Marble, Caesar Stone or COrian
• Excellent adhesion onto many different substrates without primers or activators

Applications

  General Preparation Guide

• Mask substrates if applicable
  
• Abrade substrates to be bonded /sealed with 120grit paper to create a mechanical key.
• Clean substrates with Methylated Spirits or 100% Industrial Alcohol Cleaner ensuring that substrates are free from dust, dirt, oils and any other contaminates. Allow time for cleaning solvent to evaporate.
• Apply primer if required (refer technical data sheet)
• Apply Fixtech adhesive/sealant to the prepared surface
• First “Dry Tool” off to ensure the adhesive sealant is in position and all the bond zones are sealed, then if required you can secondarily tool the surface with a sprayed solution containing a liquid pH neutral mild soap diluted with clean water, spray over the surface of the adhesive sealant and tool as required before a skin has formed. DO NOT TOOL WITH SOLVENTS
• Remove the masking tape at this time pulling along and away from the adhesive sealant. Do not pull vertically off the sealant as this could cause a lift in the adhesive sealant if it was not terminated on the masking tape edge.
• Clean up excess adhesive/ sealant from the substrate with Methylated Spirits or 100% Industrial Alcohol Cleaner. Be careful not to touch the sealant you want to keep as this will damage the sealant
• Application temperature: +5°C - 35°C